Custom Built

With over 7 years experience in addition to 20 years’ experience in the Sauna Industry, Sauna King can provide specialist consultation, design and construction of authentic, custom built, high quality Saunas to meet your individual needs.

Unfortunately, we are unable to take any more orders
for Custom Built Saunas due to high demand until further notice.

From private residence and boutique locations through to commercial clubs, gymnasiums and prestige hospitality locations Sauna King has the experience and reputation you can depend on.

From a private 1 person Sauna to a large commercial installation, only a Sauna King Sauna is built with the highest regard to Finnish tradition and craftsmanship, offering the unique health benefits of an authentic Sauna, whilst presenting a stunning and prestigious enhancement to any home or lifestyle.

Only our experienced Finnish carpenters can achieve the true heart and soul of a traditional Finnish Sauna, with the use of the finest quality materials including genuine premium grade western red cedar, unique lining and insulation materials, bench and door finishes, and all electric componentry meeting Australian standards of quality and energy efficiency, and installed by qualified Australian licensed Electricians.

Upon completion your Sauna is handed over with full instruction, backed up with a complete warranty and after-sale support and service. Regular service intervals and schedules can be prepared and maintained for clients with high traffic applications.

We pride ourselves on our reputation, detail, workmanship, quality, integrity and prompt customer service. Please let us help you enjoy the wonderful benefits of an authentic Finnish Sauna – relax and enjoy today!

Preparing for your Custom Built Sauna:

Below are some key points to take into consideration:

Floor Waste/Drain-Tap:

Not essential however it is recommended a floor waste/drain be added to your sauna room. Also not essential a tap inside your Sauna is an addition which can be used to fill your Sauna Pail without leaving the room.

Waterproofing:

In a rendered/brick/block work room floors should be waterproofed and waterproofing should also be returned 100-150mm up the wall. Timber stud walls will require a 100-150mm Fibre Cement sheet added to support skirting tile, floor and fibre cement sheet will then be waterproofed.

Floor Finishes:

The most common flooring used in a Sauna is a non slip tile with 100-150mm skirting tile. Other options are stone or polished concrete. Please note the floor in a sauna does not get hot.

Sauna Doors:

Must open outwards and have no latches or locks. Internally a timber handle must be used and the door usually has a viewing window. The recommended door opening size is 1980 x 750mm.

Power Supply (Heater):

Sauna Heaters are hard wired and require a dedicated circuit from the switchboard. Large heaters over 9kw require a separate SAWO Innova Controls, dedicated circuit will then run via the control panel before terminating at heater. Please check with us to size of cable required for your sauna. SAWO Sauna Heaters can support either a single phase or three phase supply, heaters over 8kw are recommended to be connected to three phase.

Power Supply (Lights):

A switched light feed to under bench Sauna lights – approximately 700mm off the finished floor. The light switch must be located outside the Sauna Room.